INTRODUCTION. This service manual describes the latest service information for the ICH DUAL BAND FM TRANSCEIVER at the time of publication. View and Download ICOM ICH instruction manual online. DUAL BAND FM TRANSCEIVER. ICH Transceiver pdf manual download. View and Download Icom ICH operating manual online. VHF/UHF Radio. ICH Radio pdf manual download.
|Published (Last):||26 October 2018|
|PDF File Size:||3.56 Mb|
|ePub File Size:||15.94 Mb|
|Price:||Free* [*Free Regsitration Required]|
I Memory Channel Selection I Function Display I Memory Clearing For memory channel watch: I Transferring Bank Contents I Programming A Dtmf Code Page 3 For U. Using this function you can transmit without pushing and holding the PTT switch. I Memory Clearing Mmanual Memory clearing Contents of programmed memories can be cleared blankedif desired.
Any memory channel can be recalled from either left or right band. I Call channel 2720g Call channel is pre-programmed memory channel that can be accessed by simply pushing call channel button.
Manual Downloads | Icom Inc
I Tuning Step Selection D Frequency lock This function locks [DIAL] and switches electronically and can be used together with the microphone lock function.
The transceiver has 2 different lock manua. I Accessing A Repeater Basic Operation I Receiving q Set the audio level for the main band. Connect the supplied microphone to either the desired con- nector as illustrated below. By pressing ‘print’ button you will print only current page. Selecting the operating frequency band The ICH has 2 m and 70 cm bands for each left and right band. NEVER remove the fuse holders.
Don’t have an account? Set the subaudible tone repeater tone encoder function ON.
I Using The Tuning Dial D Location Select a location which can support the weight of the trans- ceiver and does not interfere with driving. To print the manual completely, please, download it.
The ICH is equipped with protection circuit to protect the power amplifier circuit from high SWR and temperature. Outputs both left and right bands audio when no external speaker is connected to [SP-2]. I Receiving q Set the audio level for the main band. Ferrite core D Microphone connection Two microphone connectors are available for the ICH— one is on the controller side panel, and another is on the main unit front panel.
This function cuts a transmission OFF after 1—30 min. While operating on the main band, a beep sounds to inform you that a signal was received on the sub band.
This may distort the signal. The fan rotates during transmit and for 2 min.
Using The Mounting Bracket D Location Select a location which can support the weight of the trans- ceiver and does not interfere with driving. I Scan types Scanning searches for signals automatically and makes it easier to locate new stations for contact or listening purposes. D Adjusting the transmit signal output from the TNC When setting data transmission speed to bps, the data signal coming from the TNC is applied exclusively to the in- ternal limiter circuitry to automatically maintain band width.
I Repeater Operation I Repeater operation 1.
I Programming A Memory Channel I Programming a 220h channel VFO settings, including the set mode contents such as sub- audible tone frequency, offset, can be programmed into a memory channel. I Auto Repeater usa Version Only To activate all functions access or to change frequency via the microphone, you must designate one band as the main band.