INTRODUCTION. This service manual describes the latest service information for the ICH DUAL BAND FM TRANSCEIVER at the time of publication. View and Download ICOM ICH instruction manual online. DUAL BAND FM TRANSCEIVER. ICH Transceiver pdf manual download. View and Download Icom ICH operating manual online. VHF/UHF Radio. ICH Radio pdf manual download.
|Published (Last):||9 March 2014|
|PDF File Size:||19.23 Mb|
|ePub File Size:||9.96 Mb|
|Price:||Free* [*Free Regsitration Required]|
I Call Channel Transferring Specifications And Options I Front Panel- Controller Main And Vco Units Independent tuning step for the left and right, as well as each frequency bands can be set for individual tuning convenience. Selects low output power Selects minus duplex operation.
This device complies with Part 15 of the FCC rules. I Skip channel setting The memory skip function speeds up scanning by checking only those memory channels not set as skip channels.
I Using The Keypad D Adjusting the transmit signal output from the TNC When setting data transmission speed to bps, the data signal coming from the TNC is applied exclusively to the in- ternal limiter circuitry to automatically maintain band width. Repeater Operation Set the subaudible tone repeater tone encoder function ON.
ICOM IC-2720H Manuals
Scan does not operate. I Packet Operation Got it, continue to print.
When narrow is set, the transmission mwnual and reception passband width become half of the wide setting approx. I Memory Clearing I Memory clearing Contents of programmed memories can be cleared blankedif desired.
Selecting the operating frequency band The ICH has 2 m and 70 cm bands for each left and right band. I Lock Functions While operating on the main band, a beep sounds to inform you that a signal was manal on the sub band. I Programming A Dtmf Code I Memory Channel Selection Call Channel Operation Selects high output power. Page 89 D Adjusting the transmit signal output from the TNC When setting data transmission speed to bps, the data signal coming from the TNC is applied exclusively to the in- ternal limiter circuitry to automatically maintain band width.
I Receiving q Set the audio level for the main band. I Repeater Operation I Repeater operation 1. I Dtmf Speed Outputs both left and right bands audio when no external speaker is connected to [SP-2]. For memory channel watch: Connect the supplied microphone to either the desired con- nector as illustrated below.
I Memory Bank Selection I Set Mode I Monitor Function I Main Unit Thus the steps 3 and 4 may not be necessary, depending on the setting. Call Channel Operation I Call channel selection Call channel is pre-programmed memory channel that can be accessed by simply pushing call channel button.
ICH Downloads – Icom America
Using the HM q In VFO mode, set the desired operating frequency, includ- ing offset direction, tone settings, etc. The watch resumes according to the selected scan resume condition. I Scan Resume Condition I Pocket Manial Operation Page 5 I Selecting output power I Microphone hm The transceiver has 2 different lock functions.
Even if the memory bank contents are cleared, the memory channel contents still remain pro- majual. See the table below for details.
I Fuse Replacement V Connects the controller unit with the supplied cable. Quick Reference Guide I Tone Scan I Skip Channel Setting I Skip channel setting The memory skip function speeds up scanning by checking only those memory channels not set as skip channels. This function cuts a transmission Manuap after 1—30 min. The attenuator function can be deactivated in initial set mode. I Data Cloning The selected resume condition is also used for priority watch.
I Transferring Bank Contents